What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 23.06.2025 01:24
what exactly is a ‘surge’ protector?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
There are three different concepts here that are getting confused.
Your Apple Watch Is Getting a Neat New Feature That You’ll Actually Use - Gear Patrol
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
It also is a device that limits the change in current flow.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
The third is lightning and “how it gets conducted into a home.”
He then asserts :
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
When was you wife swapping fantasy started?
the problem then depends on "how fast does the fuse operate?".
But… the neutral is now “floating” because of the 1 ohm resistance.
Because the load is inductive, the current lags the voltage.(by a bit).
Win a signed pink cycling jersey of Giro winner Simon Yates - Team Visma
Barnstars:
He then describes the function of a fuse.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
How is a narcissist likely to handle situations when confronted with hard truths about themselves?
eight
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
This is where this question deviates from being a 'generic' question, and becomes more specific.
nine
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
An AC voltage/ current source, and an ac inductive load.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
A circuit breaker is similar, but is resettable.
Is it okay for me to wear girls’ underwear?
Edit 2024–10.
It seems Mohan does not understand the difference between a comment and an Answer.
He then describes Rainy Season and Lightning.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
So, the voltage could go up to 500 volts, and the fuse will not open up.
First Sentence:
Popular Diabetes Drug Linked to Longer Life – Could It Help You Live Past 90? - SciTechDaily
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
At least they know the answer if they wanted it.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
The #1 Spice to Help You Poop, According to Dietitians - EatingWell
A fuse is a non-resetable over current circuit protector.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Trump Questioned Extent Of Musk’s DOGE Cuts, Report Says - Forbes
Now when you have a certain ac resistance, then a current flows in a loop.
Here is a simplified AC power diagram.
2024–10–16 [ OO OLAOYE OYEBODE ]
New Non-Opioid Drug Offers Powerful Pain Relief Without the Dangerous Side Effects - SciTechDaily
so, what happens?
Upvotes:
For this case there are devices called Metal oxide varistors (MOV).
Are you more of a butt guy or a boob guy?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
These are simplified answers to the original question, and does not change anything I wrote above.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
There are two important concepts here.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
[old diagram got deleted by accident]
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
In schematic diagrams this is the symbol for a fuse:
These devices are installed between the “hot” and “neutral” and protective ground.
What does a fuse do?
This is where the MOV conducts again, and dissipated the energy.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
The bolt then partially travels down the line to your home.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
(Dc diagram shown, AC is similar).
[image of Common-mode choke]
One
but I think this circuit , shows a few more pieces.
At one ohm, the resistor has a maximum of 1 watt power.
but this device (an Inductor) … impedes the rapid changes in the current.
One is “what exactly is in a ‘surge protector’ ? ”
But it can get overloaded, and no longer works.
The MOV will conduct when the voltage exceeds 50% of line voltage.
What is lightning?
This one hit behind the barn.
2024–10–14 [Omar Gharbi Omar Gharbi ]
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
I post the exact comment here.
The other is “what does a “fuse” do?”
This is 'the assistant's answer'
This device then solves the entire problem.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
2024–10–10[John johnson John Johnson ]
a photo is worth a thousand words.